Cable accessories < 1 kV

The most important task of the accessories is to create a safe electrical connection, insulation and provide mechanical protection.
The product range includes accessories designed on different principles with different properties.
Accessories which utilize tape technology are simple to use, flexible and unaffected by the dimensions of the cable. Cable accessories which utilize heat- shrink technology offer a simple alternative.
Cast resin products are the obvious choice in slightly more challenging environments. The robust joint is able to cope with a depth of water of 10 m, for example, and can be used for both power and control cables. Cast resin is non-hazardous according to the Swedish Occupational Safety and Health Act’s stipulated to marginal value for non-hazardous joint.

Cable joint, branch for plastic-insulated cable

Design:
The joint consists of a transparent, impact- resistant casting mould with flexible sealing rings between the casting mould and the cable.
The cast resin and hardener are exactly measured in a two-part bag. The compound can be filled in the joint without any special protective measure.
Branching takes place with the help of clamps, which penetrate the insulation on the main cable. The clamps, which are included in the kit, are tightened with a torque wrench.

Cable joint, heat-shrink for plastic-insulated cable

Design:
The kit contains four inner sleeves and one outer sleeve.
The sleeves are made of cross-linked polyethylene.
The sleeves are coated internally with a hot-melt adhesive and are installed with heat

 

Cable joint, tape for plastic-insulated cable

Use:
For jointing 1 kV plastic-insulated cable with 3-, 4- and 5-cores, with or without screen
Design:
The kit contains insulating vulcanizing tape and electrical tape. Also includes a copper net. Insulating vulcanizing tape is used for insulation of the connectors. The stripped cable sheaths and electrical tape are used as outer protection. The joints are packed in kits.

Cable termination Protective hood for plastic-insulated cable

Use:
Termination outdoors for 1 kV plastic- insulated underground cable with 3-, 4- or 5-core, 2.5-95 mm2
Design:
The cable termination consists of a hood made of weather-proof and oil-resistant rubber. The cable cores are bent downwards and fixed with tape and are protected against UV-radiation with a type IS insulating hose.
The hood is then pushed on.